I have been looking without success for an extension that helps me make boxes with box joints (square joints), using make 2017.
I was thinking of a button that will open a dialog asking for the following:
- Box dimensions (I work in mm but could be inches as well to help other people), W/L/H.
Number of joints in each dimension (I use odd number of joints so 3,5,7,9,11, etc, but if you could input a number that would be great, again for W/L/H separately.
Material thickness.
Option to have the box with or without lids (so option for 6 faces, 5 faces, or 4 faces), 6 faces is full box, 5 faces is box without a single lid, and box with 4 faces is just the walls of the box without both lids.
All walls and lids are a different group or component, so they don't merge all lines.
As a special requirement:
For lids: The lids with odd odd number of joints always have the corners without sockets, (don't start the lid with a socket on the corner, only the inside of the lid wall have sockets).
For walls: On a rectangular box the small largest wall segments always have the corners without sockets, and the small segments always have corners with sockets.
example (you cannot see on the example which wall is larger or not, but just believe the annotations

https://ibb.co/SKk48Hf
Thanks for you help,
Winsrp