Speed Modelling Challenge #38 - Fishing
40 posts
• Page 2 of 2 • 1, 2
Re: Speed Modelling Challenge #38 - FishingDamnit, and I thought I was going to win this one
![]()
Re: Speed Modelling Challenge #38 - Fishing (Starfish)This is a Starfish modeled by me. Modelling time is approximately 25 minutes. The basic starfish was done in around 7 minutes. Took most of my time figuring out how to use the make fur plugin.. I used the artisan plugin, FredoScale plugin(radial bending by selection of plane and angle) and the make fur plugin. Sadly only a few days left with artisan trial...
![]() Re: Speed Modelling Challenge #38 - FishingEntry at the last hour, hopefully I'm not late
Re: Speed Modelling Challenge #38 - FishingNice. Still in time.
In fact there is still just over an hour to go.
Re: Speed Modelling Challenge #38 - FishingTime is up. I will get the voting up soon.
Re: Speed Modelling Challenge #38 - FishingI was going to model this with Artisan, but I didn't have a clue where to start. It's beyond my ability to do this in 1/2 hour. . . Anyway. .. not an entry obviously but plenty of good intentions.
![]() but this is basically how fishing goes for me. If I make it look easy. . .then it probably is.
Re: Speed Modelling Challenge #38 - FishingDid you sketch that David? Cause it is nice.
I am sure someone here will try to do it now that you laid it out there... ![]()
Re: Speed Modelling Challenge #38 - Fishingyeah. .. it was just a quick 5 minute doodle to get the idea. . . but then . ..oh oh. . .no way can I model that.
You could! D If I make it look easy. . .then it probably is.
Re: Speed Modelling Challenge #38 - Fishing--pupil forever...------
40 posts
• Page 2 of 2 • 1, 2
|