Rogue's W.I.P's!

[Rogue®]

So, did that explain it sufficiently Bryan?

Here is another update. Have been trying something a little different with the panel gap, in trying to make it look a lot more realistic, while not going all out on poly count. So far I can say that the results are fairly good, but it requires a lot of work and likely won't be done for future models.

Rogue Puma 01.png

Rogue Puma 02.png

I also want to do something like the Zakspeed Capri

zakspeed.jpg

[Bryan K]

Thanks Ben.

Yes, sort of. I am experimenting now with the current WIP.

2 days later I was able to recreate the technique and it's work great.

Thanks again!

[Rogue®]

Here is an update on the engine bay, which is quickly becoming my most detailed yet

Rogue Puma engine.png

[Bryan K]

Looking good!

[Rogue®]

Here it is!
https://3dwarehouse.sketchup.com/model/ ... Rogue-Puma

2020 Rogue Puma 01.png

2020 Rogue Puma 02.png

2020 Rogue Puma 03.png

2020 Rogue Puma 04.png

2020 Rogue Puma 05.png

2020 Rogue Puma 06.png

[Rogue®]

Started work on the race version

2020 Rogue Puma R-Spec 01.png

2020 Rogue Puma R-Spec 02.png

[Bryan K]

Wow! That's looking great!

[Rogue®]

Front tube-frame basically complete

2020_Rogue_Puma_R-Spec_01.png

[Bryan K]

Nice!

[Rogue®]

Uploaded a 'new wheel', it's a rebuild of my D-011
https://3dwarehouse.sketchup.com/model/ ... ogue-D-045

Rogue D-045.png

Also started work on a new model after coming up with some ideas. It's a bit of a mix between an MR2, a 300ZX and a Ferrari F355

2020_Rogue_300MR_00.png

2020_Rogue_300MR_01.png

[Rogue®]

Just updated the previous wheel, wasn't entirely happy with it

Rogue D-045.png

Also just made a 5 spoke version of my D-044

Rogue D-046.png

and a race version of my D-039, from my upcoming Puma R-Spec

Rogue D-047.png

Find these in my signature below

[Mike Amos]

Very sharp.

[Rogue®]

Very sharp.

Thanks Mike!

Here is a reworking of another one of my old wheels.
https://3dwarehouse.sketchup.com/model/ ... ogue-D-048

Rogue D-048.png

[Rogue®]

Yet another wheel, this is basically an Enkei RPF1
https://3dwarehouse.sketchup.com/model/ ... ogue-D-049

Rogue D-049.png

[Bryan K]

Top notch!

[Rogue®]

Had a fairly productive day again today, hope you enjoy these wheels!

Wheels.png

3DWarehouse link below

[Mike Amos]

Does a shark poo bear in the, never mind but yes, I do like those.

[pbacot]

Nice Wheels! Great offering. Thank you!

[Bryan K]

Ohhh, those are nice!

[Rogue®]

I though I should share this 'tutorial' model here. It's a quick guide to how to manually Sub-Divide mesh. This is the method I prefer to use at least

Manual SDS Example (2016 format).skp