Dynamic Component and material

Dynamic Component and material

Postby rsekar24 » Sat Apr 13, 2019 2:52 am

Hi all.,

I am creating a Dynamic component of a ply panel with laminates fixed on both sides. (18mmthk x 550 (w)x 700 (h)). I would like to make a report for the cutlist, such that the panel is listed with the description of the two laminates. ( Ie. "Off White laminate - American Walnut) in the material. How to achieve this. any ideas??

Thanks & Regards
R.Sekar
0

rsekar24 
 

Re: Dynamic Component and material

Postby pcmoor » Sun Apr 14, 2019 12:41 am

Hi
you can make each face a group, then paint them directly or with formula
Have the parent reference them with a custom attribute which you can add to your report, so all in same context
1

pcmoor 
 

Re: Dynamic Component and material

Postby rsekar24 » Sat Apr 27, 2019 2:24 am

pcmoor wrote:Hi
you can make each face a group, then paint them directly or with formula
Have the parent reference them with a custom attribute which you can add to your report, so all in same context


Thanks to u, will try and let u know.
1

rsekar24 
 

Re: Dynamic Component and material

Postby rsekar24 » Fri May 24, 2019 5:27 pm

rsekar24 wrote:
pcmoor wrote:Hi
you can make each face a group, then paint them directly or with formula
Have the parent reference them with a custom attribute which you can add to your report, so all in same context


Thanks to u, will try and let u know.


Hi .,

i am getting the output like the attached file and not i expected as in single line for the side panel DC as intended in the earlier post.

Attached herewith the skp file for your review.
Advice, where i am making error.

Thanks & Regards.,
R.Sekar
0

rsekar24 
 

SketchUcation One-Liner Adverts

by Ad Machine » 5 minutes ago



Ad Machine 
Robot
 



 

Return to Dynamic Components

Who is online

Users browsing this forum: No registered users and 1 guest

Visit our sponsors: