Jack it Up

To access this forum when logged in, please, sign up to the Woodworking User Group in your User Control Panel.

Jack it Up

Postby Dave R » Tue Feb 26, 2019 3:15 pm

Here's a little machinist's jack I modeled up this morning for the heck of it. SU and LO 2019. For reference, the body of the jack is 55 mm tall. Screw threads are 16mm x 2.

6
%

(THERE'S NO PLACE LIKE)

G28 X0.0 Y0.0 Z0.0

M30

%
User avatar
Dave R 
Global Moderator
 

Re: Jack it Up

Postby HornOxx » Tue Feb 26, 2019 8:18 pm

:thumb: wonderful again - especially this diamond flute (didn't you recently post a thread cutter(?) with it too?) is perfectly done. I also want to deal with how to model such a perfect thread :-)
How was the cut drawing with the grey filling made?
0
never trust a skinny cook
User avatar
HornOxx 
 

Re: Jack it Up

Postby Dave R » Tue Feb 26, 2019 8:31 pm

Thank you, sir. The diamond knurling was used on the handles of the tap wrench I drew a few weeks ago. I also used it on a little brass pin a couple of years ago. In fact, it's the same knurling components. :D

The fill on the section cut is just done by turning it on as part of the style. This is a feature of SU2018 and 2019.
1
%

(THERE'S NO PLACE LIKE)

G28 X0.0 Y0.0 Z0.0

M30

%
User avatar
Dave R 
Global Moderator
 

Re: Jack it Up

Postby tuna1957 » Wed Feb 27, 2019 3:03 am

super ! :thumb: :thumb:
0

tuna1957 
Premium Member
Premium Member
 

Re: Jack it Up

Postby Dave R » Fri Mar 01, 2019 5:05 am

A certain someone suggested I should make a render of the jacks so I did. They are brand new. One waiting for assembly. This accounts for the lack of scratches and grime. :D

3
%

(THERE'S NO PLACE LIKE)

G28 X0.0 Y0.0 Z0.0

M30

%
User avatar
Dave R 
Global Moderator
 

Re: Jack it Up

Postby HornOxx » Fri Mar 01, 2019 6:16 am

:) Perfect, just perfect!! these threads in both, bolt and nut, are perfect (and I'm still thinking about how it works :) )
0
never trust a skinny cook
User avatar
HornOxx 
 

Re: Jack it Up

Postby Dave R » Fri Mar 01, 2019 3:27 pm

Thank you.

HornOxx wrote::)(and I'm still thinking about how it works :) )


Do you mean you're still trying to figure out how to model the screw threads?
0
%

(THERE'S NO PLACE LIKE)

G28 X0.0 Y0.0 Z0.0

M30

%
User avatar
Dave R 
Global Moderator
 

Re: Jack it Up

Postby L i am » Sat Mar 02, 2019 8:36 am

Amazing and as I said before the knurling is unbelievably good, as is the redndering :thumb: :thumb:
0

L i am 
Premium Member
Premium Member
 

SketchUcation One-Liner Adverts

by Ad Machine » 5 minutes ago



Ad Machine 
Robot
 



 

Return to Woodworking

Who is online

Users browsing this forum: No registered users and 1 guest

Visit our sponsors: