component question

[ianccc]

I created this component (link below)for our Local festival - I am in charge of signage and last year the plastic signs disinigrated so I an going to dust off the welder and make one to last

http://sketchup.google.com/3dwarehouse/ ... 144e458307

Question can someone have a look and see if there are any real problems with my model - I relize there is some alighment + problems with the handle

any info appreciated

[ianccc]

Yikkes - it's worse than I thought - I just downloded it off 3D warehouse
I thought I re-saved the individual sign pickets with a different component name, what I am seeing is a jumble

part of my component is always highlighted - is there a easy to unselect - not sure why this is happening

~ian

[Krisidious]

downloaded fine for me...

to unselect either hit escape a few times or double click out in the open.

[Krisidious]

other than line up issues... like you said. all I would do is perhaps make a box for ballast at the bottom, or build it up more to weight it down.

also the handle is a bit much for me... why not just put a grip around the pole at the middle... it's just for moving it right?

otherwise... I'm sure this thing will last forever...

[ianccc]

thanks for the info - it worked I was able to
un-select the component
Yep - I will lose the handle and possible beef up the bottom plate with 1/2" steel

thanks again

~ian