First Model & a Few Questions

The ideal place for beginners to get help using SketchUp

First Model & a Few Questions

Postby randallwise » Fri Nov 30, 2007 11:25 am

Thanks for all your input. I'm still not quite getting the component creating, I guess. If you look at the model again, there is a new component window, the super long one on either side of the top of the building. There are some windows that won't go translucent, and for some reason, the wall went off vertical on one side.

Also, on the corner of the bulding with the recess portion, the roof is cut out. I can't figure out how to correct this. Something happened and I suddenly had angles everywhere and odd faces.

I created the columns and then did used the 'intersect' tool to intersect w/ the model. Everything seemed fine until that corner, then my walls, roof, etc. were all funky.

Any help is greatly appreciated!

I'm getting the hang of this, I think!

RSW

Nutra_Ogden.skp

P: randallwise
0

randallwise 
 

Re: First Model & a Few Questions

Postby tomsdesk » Fri Nov 30, 2007 11:27 am

Randall, I get the same model as before...no columns or new windows?
I'll check again tomorrow.
0

tomsdesk 
 

SketchUcation One-Liner Adverts

by Ad Machine » 5 minutes ago



Ad Machine 
Robot
 



 

Return to Newbie Forum

Who is online

Users browsing this forum: No registered users and 3 guests

Visit our sponsors: